Cut
optimizer
Enter the pieces you need and I’ll tell you how to get them out of the fewest sheets or bars. No sign-up, and you get the plan as a PDF to take to the workshop.
Your cutting plan
Pieces in yellow and waste hatched. The offcut shows its length if it’s worth keeping (10 cm or more).Pieces in yellow and waste hatched. The offcut shows its length if it’s worth keeping (about 4 in or more).
Pieces in yellow; usable offcuts in white with their size. The DXF file only contains the cut lines: the outline of the sheet and of each piece at full size (in millimetres), each on its own layer. The toolpath (outside the line), tabs and depth are set in your CNC software.Pieces in yellow; usable offcuts in white with their size. The DXF file only contains the cut lines: the outline of the sheet and of each piece at full size (in inches), each on its own layer. The toolpath (outside the line), tabs and depth are set in your CNC software.
Every layout uses straight edge-to-edge cuts (“guillotine” cuts), so you can do them with a track saw, a sliding table saw or a panel saw. Pieces in yellow; usable offcuts in white with their size.